Butterfly Shower Door & Base SHOWER Door AND SHOWER BASE INSTALLATION INSTRUCTIONS IMPORTANT DreamLineTM reserves the right to alter, m
“BUTTERFLY” Rev.3 Ver.3 03/2014 9 9. Locate the Guide rails (03) and the Glass profile (02). Connect the left end of the Gu
“BUTTERFLY” Rev.3 Ver.3 03/2014 10 10. Slide the pre-installed Door assembly 1 (as showing in Fig. 5) into the channel of the Guide rails (03)
“BUTTERFLY” Rev.3 Ver.3 03/2014 11 12. Slide the pre-installed Door assembly 2 (that showing on Fig. 10) into the channel of the Guide rai
“BUTTERFLY” Rev.3 Ver.3 03/2014 12 13. Attach the other Glass profile (02) at the right side of the door unit and fasten it to the Guide rails
“BUTTERFLY” Rev.3 Ver.3 03/2014 13 15. Attach the Roller stoppers (16) inside the top and the bottom Guide rails (03
“BUTTERFLY” Rev.3 Ver.3 03/2014 14 Shower Door Installation 16. The Tub or Shower base should be installed prior to installation. The Showe
“BUTTERFLY” Rev.3 Ver.3 03/2014 15 17. Push the Wall profiles (01) over the Glass
“BUTTERFLY” Rev.3 Ver.3 03/2014 16 18. Move the assembled Door unit on the Shower base or the Tub and butt the Wall profiles (01) up against th
“BUTTERFLY” Rev.3 Ver.3 03/2014 17 20. Make final adjustment if required. Drill the holes through the first layer into the Wall profiles (01) a
“BUTTERFLY” Rev.3 Ver.3 03/2014 18 22. Mount the Handles (17) onto the both Glass doors B & B2 (05). Cover the screw holes on the Handles
IMPORTANT DreamLineTM reserves the right to alter, modify or redesign products at any time without prior notice. For the latest up-to-date technica
“BUTTERFLY” Rev.3 Ver.3 03/2014 1924. Apply silicone along the Wall profiles (01), as well as along the bottom Guide rail (03). See Fig
SLIMLINE SHOWER BASE SHOWER BASE DIMENSIONS AND INSTALLATION INSTRUCTIONS IMPORTANT DreamLineTM reserves the right to alter, modify or redesign
“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 2Preparation 1. Examine boxes and packages for shipping damage. Carefully remove Shower base from th
“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 3SINGLE THRESHOLD SHOWER BASE Center Drain Configuration MODEL SPECIFICATION D (in) W (in)
“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 4Left-Hand Drain Configuration MODEL SPECIFICAT
“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 5Right-Hand Drain Configuration
“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 6NEO SHOWER BASE MODEL SPECIFICATION W (in) A (in) B (in) C (in) DLT-2
“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 7QUARTER ROUND SHOWER BASE MODEL SPECIFICATION W (in) C (
“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 8DOUBLE THRESHOLD SHOWER BASE Corner Drain Configuration MODEL SPECIFICATION W (in) C
“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 9Left-Hand Drain Configuration MODEL SPECIFICATION D (in) W (in) D1 (in) W1 (in)
“BUTTERFLY” Rev.3 Ver.3 03/2014 2 Preparation 1. After opening all boxes and packages, read this introduction carefully. Check that all of
“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 10Right-Hand Drain Configuration MODEL SPECIFICATION D (in) W (in) D1 (in)
“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 11Diagram of the Shower Base in a Cross Section Finished Wall Cement board S
“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 12Shower Base Installation Preparation 1. Ensure that the floor and the studs are at right angle. Pr
“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 132. Install the shower drain (NOT PROVIDED) according to the drain installation manual (supplied wit
“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 14 4. Level the tray and place marks on the studs above the upper edge of the tile flange. See
“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 15 6. After the bedding material has been poured and before it sets, place the shower base into the p
“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 16 Fig. 9 Product maintenance To insure long lasting life
DREAMLINE™EXCLUSIVELIMITEDWARRANTYASOFMAY6,2013Thiswarrantyextendsonlytotheoriginalowner/end‐userforhouseholduseonlyandisnottr
TEL: 866-731-2244 FAX: 866-227-1533 WWW.BATHAUTHORITY.COM For more information on DreamLineTM Shower Doors please visit www.Bath
“BUTTERFLY” Rev.3 Ver.3 03/2014 3Detailed Diagrams of Shower Door Components B2AA2B876910234511121314151617181319 Packing List 01 Wall prof
“BUTTERFLY” Rev.3 Ver.3 03/2014 4Shower Door Assembly Note: There are two separate Butterfly models featuring two different glass variations.
“BUTTERFLY” Rev.3 Ver.3 03/2014 5 2. Attach the top and the bottom Hinges (13) to the left edge of the Glass door A (04). Mind the position of
“BUTTERFLY” Rev.3 Ver.3 03/2014 6 4. Connect the Glass door A (04) to the Glass door B (05) using the Middle hinges (11). Mind the position of
“BUTTERFLY” Rev.3 Ver.3 03/2014 7 5. Place the other Glass door B2 (05) and the other Glass door A2 (04) on a flat surface. The distances from
“BUTTERFLY” Rev.3 Ver.3 03/2014 8 7. Attach the top and the bottom Hinges (13) to the right edge of the Glass door A2 (04). Mind the position
Komentáře k této Příručce